Gun Hub Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
I purchased a walnut stock from Fred's for my M1A springfield. The fit is very tight, the back of the receiver lacks approximatly 1/2 inch bottoming. How much force should one use, should I use the trigger guard to seat the rifle? My issued M14 in 1965 just seem to fall into the receiver. any help or suggestions would be appreciated.
rboone
 

·
Registered
Joined
·
819 Posts
You might find that you need to loosen up on the 2 stock liners screws ,install the receiver and then tighten down after seating the receiver, it could be just the liner needs to be tweaked to your receiver.
Hope this helps!
Mike
 
1 - 2 of 2 Posts
Top