Gun Hub Forums banner
1 - 1 of 1 Posts

· Registered
5,151 Posts
Discussion Starter · #1 ·
Since I no longer have any of the Machinery I had when I worked fulltime I have to outsource this work.

The Chamber-Throats on my M44-6HV Dan Wesson Cylinder are way undersized. They average .426, I need them reamed out to .431. Does anybody know of a Gunsmith who does this type of work? If so, do you have his contact info and pricing?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.