Gun Hub Forums banner

R1

1536 Views 10 Replies 5 Participants Last post by  Cap'n Dex
I went to turn in a job application today(still employed, just hate working for the french, so I'm looking) and in the display case the shop had 2 Remington R1 pistols. 1 was $650 and the other was $575. Ok. I asked them why the one was cheaper, they looked the same. The cheaper one was a factory promo. Ok. I did some math on my phone in the parking lot, and it all added up, it was a good deal. I was going to buy a Cimarron for $550. $25 more for a (like) new remington? Um, yeah, wrap it up for me, please. haha. $615 out the door. The guy at the shop told me its pretty much the best buy in 1911s on the market right now. You can spend more, but not get more. Agreed. haha. The guy even said what they're doing is renting only Remingtons for range 1911s eventually.

I still have to shoot it. I stopped by walmart on my way home, and picked up 50rds of the "for walmart" Federal ammo. The spring is tight. The safety is crisp, the trigger pull is light. The hammer cocks pretty easily. No scratches, or blemishes of any type that I could see. That heavy recoil spring is going to take a little getting used to. My other 1911 is a GSG .22, and my "other 1911" is a Sig P238. I'd continue writing about it, but then I'd have to wait longer to shoot it. haha. Well, Thanks for reading!
1 - 2 of 11 Posts
I recently shot one that had a very small drop in beavertail similar to the ones kimber is shipping on some carry guns. It was quite nice. Decent trigger, well machined and fit, very little rattle and quite accurate. We were holding sub three inch groups at 25 yards.
Pull the slide offand look in the area of the disconnector notch. Is there a plunger just in front of the firing pin stop and ofset slightly?
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top