Gun Hub Forums banner
1 - 5 of 5 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
Thank you, knew someone would have seen it before. Now that I know what rifle it goes to I can start the finishing process.

Do have one question; the whole at the end of the stock, originaly I thought it was setup to receive and end cap now I am wondering if it is part of the tube magazine?
 

Attachments

· Registered
Joined
·
807 Posts
I would say that hole is where the stock making machine held the stock during production. Once it has been shaped and inletted, then it would taken off the machine, and be cut off back where the magazine channel starts.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top